ultrasonic vibration device for transducer 33khz 100W

Usually, the transducer installation methods of ultrasonic vibration screen are built-in type and external type. As the name implies, the built-in transducer is installed in the middle of the grid. The only disadvantage is that it can not avoid contact with materials. For some corrosive or conductive materials, once contacted with the transducer, the service life of the ultrasonic vibration transducer will be reduced, and the transmission of the equipment will also be affected. Output frequency, reduce screening output.

 

Another disadvantage of the built-in type is that in order to clean up the transducer, the screen frame must be removed before it can be cleaned up, which is more troublesome. The external type is to install the transducer on the outside of the screen frame, and the extended part is located at the edge of the grid. The reason why the transducer is installed on the outside of the screen machine, so that there is no direct contact between the material and the transducer, which not only effectively protects the transducer, improves its service life, but also to a certain extent. It also improves the screening accuracy and output of the ultrasonic vibration screen. Because the transducer is directly installed on the outside of the screen frame, it can be cleaned directly, which is relatively simple and convenient.

Type	Frequency（KHz）	Input Power（W）
UCE-UVT-33	33KHZ	100W
UCE-UVT-35	35KHZ	100W